54
Next Page
Page 1/2
Enter the second page of the alternative trigger.
Table 2-27 Set trigger mode to slope trigger function menu 2
Option Setting Instruction
Time
〈
Set time
〉
Turn the “Universal” knob to set the slope time.
Time setup range is 20ns-10s.
Vertical
Select the trigger level that can be adjusted by
“LEVEL” knob. You can adjust “LEVEL A”,
“LEVEL B” or adjust them at the same time.
Set up
Enter the “Trigger setup menu”(see table 2-14).
Next Page
Page 2/2
Return the first page of “Alternative trigger menu”.
Operate Instruction:
Observe two irrelative channel signals, follow these steps
：
1.
Input two irrelative signals to channel 1and channel 2.
2.
Press the AUTO button.
3.
Press the TRIG MENU button to enter “trigger menu”.
4.
Press the “Type” option button to select “Alternative”.
5.
Press the “Channels” option button to select “CH1-CH2”
6.
Press the “Source” option button to select “CH1”.
7.
Press the CH1 button and turn the “S/div” knob to optimize waveform display.
8.
Press “Mode” option button to select “Edge”, “Pulse”, “Slope” or “Video”.
9.
Set the trigger according to trigger edge.
10.
Press the “Source” option button to select “CH2”.
11.
Press the CH2 button and turn the “S/div” knob to optimize waveform display.
11. Repeat steps 8 and 9.
Note:X,Y represent CH1,CH2,CH3 and CH4 respectively, but X and Y can’t represent the
same signal source.
Summary of Contents for SDS1000 Series
Page 146: ...138 Coupling DC...
