69
Track mode
Table 2-33 Track mode function menu:
Option Setting
Instruction
Cursor Mode Track
In this mode, set track cursor measure.
Cursor A
CH1
CH2
CH3
CH4
NONE
Set the input signal channel that the
Cursor A will measure.
Cursor B
CH1
CH2
CH3
CH4
NONE
Set the input signal channel that the
Cursor B will measure.
Cur A
Select this option, turn the “Universal”
knob to adjust horizontal coordinate of
Cursor A.
Cur B
Select this option, turn the “Universal”
knob to adjust horizontal coordinate of
Cursor B.
In this mode, the screen displays two cross cursors. The cross cursor sets the
position on the waveform automatically. You could adjust cursor’s horizontal position
on the waveform by turning the “Universal” knob. The oscilloscope displays the
values on the top of the right screen.
To do track cursor measurement, follow these steps:
1.
Press CURSOR button to enter the cursor measure function menu.
2.
Press the “Cursor Mode” option button to select “Track”.
3.
Press the “Cursor A” option button to select the input signal channel.
4.
Press the “Cursor B” option button to select the input signal channel.
5.
Select “Cur A”, turn the “Universal” knob to move Cursor A horizontally.
6.
Select “Cur B”, turn the “Universal” knob to move Cursor B horizontally.
7.
The measurement values are displayed on the left of the top corner:
A
→
T: The horizontal position of Cursor A (Time cursor centered around the
midpoint of screen).
A
→
V: The Vertical position of Cursor A (Voltage cursor centered around
channel ground level).
Summary of Contents for SDS1000 Series
Page 146: ...138 Coupling DC...
