80
SAVE/RECALL SETUP
■
Save Setups to Device
：
The complete setup is stored in nonvolatile memory.
When you recall the setup, the oscilloscope will be in the mode from which the setup
was saved.
The oscilloscope saves the current setup if you wait three seconds after the last
change before you power off the oscilloscope. The oscilloscope recalls this setup the
next time you apply power.
Table 2-41 Save setup to device function menu:
Option
Setting
Introduction
Type
Setups
Menu for the Storage/Recall setting in the
oscilloscope
Save to
Device
Save setup to the oscilloscope’s internal memorizer.
Setup
No.1
to
No.20 Press the “Setup” option button or turn the
“universal” knob to select storage position.
Save
Accomplish the storage
Recall
Recall the storage in the “Setup” operation
Picture 2.12-6
Save setups to the oscilloscope’s internal memorizer, follow next steps:
For example: Save setup that set waveform display type to “Dots” to internal
memory.
1
）
. Press the “SAVE/RECALL” button to enter the “SAVE/RECALL” menu.
Summary of Contents for SDS1000 Series
Page 146: ...138 Coupling DC...
