SNA5000A Vector Network Analyzer User Manual 112
End response:
Response of the limit line’s ending point.
4.7 Ripple limit test
The ripple limit test function can be performed independently of the limit test function,
and the ripple limit can be set to evaluate whether the measurement result is qualified or
unqualified. Ripple is defined as the difference between the maximum value and the
minimum value within the specified excitation range. The ripple limit function is only
applicable to the measured point value, not to the interpolation.
Ripple table setting
Click
Math→Analysis→Limit→Ripple
to open the ripple test setting interface, we can
set ripple test, sound type, and ripple table in this interface.
Figure 4-8 Ripple test setting interface
Ripple test:
⚫
Ripple test on
: Check this box to set the ripple test to "on" state and display "pass"
or "Fail".
⚫
Ripple line on
: Check this box to display the ripple limit line on the screen.
⚫
Sound on fail:
When this box is checked, the VNA will beep when the test fails.
Sound type:
⚫
Sound on fail:
When this box is checked, the equipment will beep when the test fails.
⚫
Sound on pass:
When this box is checked, the equipment will beep when the test
Summary of Contents for SNA5000A Series
Page 2: ......
