SNA5000A Vector Network Analyzer User Manual 84
Figure 3-33 de-embedding interface
N-port embedding/de-embedding operation steps:
1. Ensure that the user has completed the S parameter calibration and obtained the S
parameters of the DUT.
2. Select
Cal
→
Fixtures
→
Fixture Setup
→
N-Port DeEmbed
to enter the Settings screen.
3. Select the topology type.
There are 3 topology types:
A (using network 1)
B (using network 1 and 3)
C (using network 1, 2 and 4)
Select the port of the vector network analyzer in the VNA item, select the Network port
configuration that needs to be embedded or de-embedded in the
Network
, and select the
Embed
operation or
De-embed
operation under each Network. Finally, load the S2P file
corresponding to the operating network. Checking the
Enable 4/6/8-Port Embed/De-
embed On All Ports
tab means that all ports are matched.
Summary of Contents for SNA5000A Series
Page 2: ......
