SIGLENT Digital Multimeter SC1016 User’s Guide
WWW.SIGLENT.COM
Steps
1.Operations
WARNING
The SC1016 is not designed to be “hot swappable”. Remove power from all inputs and turn the instrument power off before installation or
removal of the scanner card. Hot swapping the card could cause damage and is not covered under the warranty.
1.Power Off
Turn the Power Off and take out the power cord
2.Open the SDM rear panel slot
Take off the two screws on the slot corners to remove the optional slot cover.
Keep the screws for later reuse
3.Connection
Turn the clamp and insert the wire.
4. Tighten cable
Route wiring through strain relief and Cable tie rap Wrap
5.Insert the SC1016
Insert the SC1016 bottom-side-up. Close the cover by tightening the screws.
6.Power On
Connect the power cord and turn On the power
①
②
①
②
②
①
Summary of Contents for SC1016
Page 1: ...SC1016 User s Guide...
