SDG5000 User Manual 109
3.8. Example 8:Generate a Burst Wave
Generate a burst waveform of 5 cycles. The period is 3ms. Use internal
trigger and 0 degree phase.
Steps:
Set the sweep function:
Press Waveforms, and choose the sine waveform as the burst function.
The default setting of the source is internal.
Set the frequency, amplitude and offset
1. Press Frequency and choose Frequency which will display in white color.
Input ‘10’ from the keyboard and choose the unit ‘KHz’ to set the
frequency 10KHz.
2. Press Amplitude to choose Amplitude which will display in white color.
Input ‘1’ from the keyboard and choose the unit ‘Vpp’ to set the amplitude
1Vpp.
3. Press Offset to choose Offset which will display in white color. Input ‘0’
from the keyboard and choose the unit ‘Vdc’ to set the offset 0Vdc
Set the sweep mode.
Press Burst →NCycle, choose NCycle Mode.
Set the burst period
Press Period, input ‘3’ from the keyboard and choose the unit ‘ms’ to set
the period 3ms.
Summary of Contents for SDG5000 series
