SDG5000 User Manual 110
Set the start phase
Press Start Phase, input ‘0’ from the keyboard and choose the unit ‘ °’ to
set the start phase 0°.
Set the burst cycles
Press Cycle, Input ‘5’ from the keyboard and choose the unit ‘Cycle’ to
set the burst cycle 5.
Set the delay
Press More 1 of 2 to choose Delay, and input ‘100’ from the keyboard
and choose the unit ‘μs’ to set the delay 100μs.
When all parameters above are set, the wave generated is shown in Figure
3- 8.
Figure 3- 8 Burst Waveform Output
Summary of Contents for SDG5000 series
