SIGLENT Remote Manual
9 SDM3055/SDM3055A
1.4. OUTPut:TRIGger:SLOPe {POSitive|NEGative}
OUTPut:TRIGger:SLOPe?
Selects the slope of the
voltmeter complete
output signal on the rear-panel VM Comp
BNC connector.
Parameter
Typical Return
{POSitive|NEGative}, default NEGative
(none)
Configure DC voltage measurements and make two measurements. The signal
on the rear-panel
VM Comp
connector will output a positive pulse as each
measurement is completed:
CONF:VOLT:DC 10
SAMP:COUN 2
OUTP:TRIG:SLOP POS
INIT
This parameter is set to its default value after a Factory Reset (
*RST
) or Instrument Preset
(
SYSTem:PRESet
).
Summary of Contents for SDM3055A
