SIG
L
ENT
120
SDS1000X User Manual
To Set Color Display
Color temperature adopts the change of waveforms’ color to reflect the change of the
waveforms’ appearing probability. The greater the probability that the waveform appears,
the warmer the color is; the smaller the waveform appears, the colder the color is.
The picture below shows the change of color from cold to warm. Press the Display button
on the front panel, and then press the
Color
softkey and set the option to
On
to turn on
the color temperature function. You can compare the waveform’s color with the picture
below to just the probability that the waveform appears.
Cold Color Warm Color
Figure 69 Color Temperature
To Set and Clear Persistence
With persistence, the oscilloscope updates the display with new acquisitions, but does not
immediately erase the results of previous acquisitions. All previous acquisitions are
displayed with reduced intensity. New acquisitions are shown in their normal color with
normal intensity.
Do the following steps to set and clear persistence:
1. Press the
Display/Persist
button on the front panel to enter the DISPLAY function
menu.
2. Press the
Persist
softkey; then turn the
Universal Knob
to select the desires option.
Off
—turn of persistence.
Variable persistence time (1 second, 5 seconds, 10 seconds, 30 seconds ) —
select different persistence time, the results of previous acquisitions are erased
after a certain amount of time
Infinite
—select ―Infinite‖ Results of previous acquisitions are never erased. Use
infinite persistence to measure noise and jitter, to see the worst- case extremes of
varying waveforms, to look for timing violations, or to capture events that occur
infrequently.
www.biall.com.pl
Summary of Contents for SDS1102X
