SIGLENT
12 SSG5000X Service Manual
LAN Port Test
Use to test the LAN interface functionality.
Tools
：
● A computer with functional LAN interface
● A standard LAN cable
Steps
：
1. Connect the signal generator and the computer using a LAN cable via LAN
interface.
2. Press
UTILITY->Interface
, Set DHCP State ON, as the figure below shows.
The signal generator will set IP Address and Subnet Mask and Gateway
automatically in this network.
3. Write down the displayed IP address. It will be used in later steps.
Figure 2-2 IP configuration interface
4.
Run NI max software. Click “Device and interfaces” in the upper left corner
of the NI software interface, select
“Network Devices”, Add Network Device,
and select VISA TCP/IP Resource as shown:.
