Operating Instructions_SD160BT
ex
_002
13
4.2 Using the base charging station for system assembly 1
(Use the base charging station
in hazardous area
)
The device has been closed ex-factory.
Incorrect handling may result in the termination of the operating
permit.
The cable connecting the base charging station to the power supply
is: SDZ10.0011.00 for USB or SD.Z10.0010.00 for RS232.
Insert the cable in the opening at the bottom of the base charging sta-
tion.
If the cable has been inserted fully you can hear a
"click". Check if the cable fits firmly.
Insert the plug of the connection cable into the power supply's plug
connector.
Ensure that the connection is fully secured with the
screw cap after the plug has been inserted.
Place the SD160BT
es
handheld scanner onto the charging station.
Insert the lower part of the handle to ensure that the contacts for
charging are connected properly.
The LED at the head of the scanner will come on to
indicate successful charging.
