Signal LCS652, Installation And Operating Instruction Manual

-12- 

SPECIFICATIONS 

Input Voltage 

10 - 16 VDC (negative ground) 

Input Current 

8 Amps @ 13.6 VDC (100W speaker) 

Standby Current 

Less than 20 mA 

Output Power 

105 WATTS RMS MAX. (15.0 VDC - single 100W speaker) 

Siren Frequency 

675Hz - 1633Hz 

High Voltage Protection 

16 - 18 VDC will cause siren output to cease, resume at normal 

Short Circuit Current 

50 AMPS (supply circuit must be capable of supplying this) 

Operating Temperature 

-15° F to +140°F 

Controls 

3-position primary mode rocker switch (Wail, Yelp, and Standby) 
Momentary 3-position rocker switch (Horn and Manual) 
Phaser disable (jumper programmable) 
Two-Tone Enable (jumper programmable) 
Auxiliary Horn Polarity (jumper programmable) 
Two 2-Position Light Control Switches (LCS652 only) 

Connections 
(12-Pin Connector) 

Detachable, 12-pin, positive locking connector with pigtail leads  
(1) Positive, (1) Negative, (2) Speaker, and (1) auxiliary Horn. 

LCS652 only:

 (2) Additional Positive 

Size 

2” High, 6” Wide, 5¼” Deep 

Boxed Weight 

3.5 lbs. 

PARTS 

The following parts are available from Signal Vehicle Products: 

Part

Description

P30235-19P 

Amplifier Top Cover 

P30234-19P 

Amplifier Bottom Mounting Plate 

SWH-27 

SS650 Wiring Harness 

SWH-83 

LCS652 Wiring Harness 

30052-30 

Rear Amplifier Case Screws 

30052-26 

Bottom Amplifier Case Screws 

30028-6 

15 Amp Automotive Blade Fuse for Amplifier 

30032-8 

TIP36C Power Transistor 

30007-41 

3-Position Rocker Selector Switch (WAIL/YELP) 

30007-42 

Momentary Rocker Switch (HORN/MAN) 

SW-40 

Lighted ON/OFF Rocker Switch (LCS652)