Rev 1.5
SignalFire Telemetry
7
Point-to-Point Mode
In Point-to-Point mode, a WIOM Mini that is set to Gateway mode will mirror its digital
inputs to the outputs of a Module set to Node, and vice-versa. Point-to-Point mode is
only valid for a pair of WIOM Mini modules. For example, if Digital Input 1 on the Gateway
is shorted to GND (logic 1), Digital Output 1 on the Node is energized, and vice versa.
Because the WIOM Mini A does not have an analog output, the analog input is not used.
Point-to-Point Mode. Inputs from one module are mirrored as outputs on the other
When set to Point-to-Point mode, the WIOM Minis will not be viewable through a SignalFire Gateway
as they will be on their own network. The module that is set to Gateway will be locked to Slave ID 1.
WIOM-Mini to WIOM Mode
A WIOM Mini and a regular WIOM can also operate in Point-to-Point mode with each other. In this
configuration the WIOM will mirror the WIOM Mini A’s analog input to its analog output 1. The DI’s
will be mirrored in both directions. The WIOM must be configured in Gateway mode while the WIOM-
mini must be in node mode.
