5
forwarding (NAPT) settings. Please note that any actions/modifications which alter the topology
of the Ethernet bridge will result in the Ethernet bridge spanning tree protocol requiring to
relearn. During this relearn period (may take up to one minute), HTTP access will be unavailable
on all bridged interfaces (including the LAN interface).
2.1 LAN Interface Settings
This sub-page allows the user to configure the private LAN interface settings.
Assign an IP address to the LAN Ethernet port. This IP address is also the default router address
for the devices on the private LAN. The default LAN interface IP address is set to
192.168.123.1
.
Enter the subnet mask for the private LAN.
If you wish to set the broadcast and multicast limits for the bridge/router, enter these values as
percentages of the LAN interface Ethernet bit rate. Leaving these values blank will imply values
of 100%.
Press "Save LAN Settings" to save and apply the LAN interface settings. Any new settings will
take effect immediately.
2.2 DHCP Server Settings
This sub-page allows configuration of the private LAN DHCP server. The DHCP server settings
do not apply if the device is operating in bridge only mode.
Specify whether the device’s internal DHCP server feature is enabled or disabled. Also indicate
the IP address range to use for DHCP assignments to the LAN. Specify the domain name
(optional) that is provided to LAN clients via DHCP. Two optional static DNS server IP
