After that you will see the final pictures after installation.
Figure 10
4. Commissioning
The following chapter outlines the process to optimize the performance of the
booster. The gain setting, isolation, downlink output power, and booster uplink
noise contribution will be considered
4.1 Commissioning Principle
4.1.1 Downlink Output Power
The total downlink output power of the booster is depending on the input power
and the booster gain. To ensure the maximum power of the booster is achieved
at the MS port of the booster, the following condition should be met.
4.1.1.1
Gain and Output Power
The gain is the amplifying ability of the booster. The booster has a constant gain
for both uplink and downlink. Both uplink and downlink gain can be adjusted by
setting attenuation values.
DL Gain = Min {(DL Required Output Power - Input Power), Maximum DL Gain}