26
MAINTENANCE
Replacing the Water Filter
Replace the Water Filter :
•
Approximately every six months.
•
When the
Replace Filter
icon turns on.
•
When the water dispenser output decreases.
1
Remove the old water filter.
Push and open up the Water Filter cover on ther
right top of freezer.
NOTE
•
Replacing the water ilter causes a small amount of
water (around 1 oz. or 25 cc) to drain.
•
Wrap a cloth around the front end of the water ilter
cover to collect any leaking water. Hold the water
ilter upright, once it is removed, to prevent any
remaining water from spilling out of the water ilter.
2
Put the cap on water filter, then grasp and rotate
it counterclockwise to remove the water filter from
the filter head.
Cap
3
Replace with a new water filter.
Take the new water filter out of its packing and
remove the protective cover from the o-rings. Put
the cap on new water filter, then push it into the
manifold hole until it stops.
4
Grasp and rotate cap clockwise until it stops.
Put the cap on the right side of Water Filter.
5
After the water filter is replaced, dispense 2.5
gallons of water (flush for approximately 5
minutes) to remove trapped air and contaminants
from the system.
NOTE
•
Do not dispense the entire 2.5 gallon amount
continuously. Press and release the dispenser pad
for cycles of 30 seconds ON and 60 seconds OFF.
•
Keep the water ilter bypass plug. You MUST use
the water ilter bypass plug when a replacement
water ilter cartridge is not available.
