7
ENGLISH
6. Installation of part to prevent the product from
falling over
1) Check if all the described parts are included in the accessory box.
2) Based on the recommended dimension on the picture, place the part to prevent the
product from falling over. (Same for both left and right side)
3) Use the M4*L12 screw included in the accessory box to tighten 3 locations respectively on
left and right side.
(Tighten the screws completely so that the part is not loose from the cabinet.)
4) Place the product on the cabinet and then use the M4*L22 screw included in the
accessory box to tighten 4 locations respectively on left and right side on the groove
marked on the picture after checking whether the product is leveled and checking the level
difference between the refrigerator and freezer door and the alignment between the front
part of the product against the cabinet etc.
(When inserting the refrigerator in the cabinet, be careful not to get the hand caught.)
Top groove
Bottom groove
< Example of installation >
< Example of installation >
4”
(100mm)
82-3/8”
(2,092mm)
< Use the M4*L12 Screw for fixing
anti tip over bracket. >
< Use the M4*L22 Screw for fixing Product. >
