Compartment A:
Compartment B:
For programmes with pre-wash only.
(Follow the user instructions!)
Mechanical indicator C.
Electric indicator on control panel (if provided).
Check the rinse aid level
Check the regeneration
salt level
Load the baskets
Select a programme
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Changing the programme
Add forgotten dishes in the
dishwasher.
If the appliance is switched
off during a wash cycle.
Open the door carefully.
Hot steam may escape
when the door is opened!
WARNING!
Switch on the appliance
Quick operation guide
For detailed operating method read the corresponding content on the instruction manual.
A
B
C
Press the Power switch button to switch on the appliance, Open the door .
For each wash cycle.
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Scrape off any large food particles. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Close the door, Press the program button until the selected program lights up.
( See the section entitled
“
Operation instruction
”
)
T urn on the water tap and press the Start/Pause button. The machine will start working
after about 10 seconds.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the
detergent may have already been released and the water already drained. If in this case, the
detergent dispenser must be refilled.
2. Press the Start/Pause button, then press the program button more than 3 seconds to cancel
the running program.
3. Select a new program.
4. Restart the dishwasher.
1.Press the start/pause button to stop the machine.
2.Open the door.
3.Add the forgotten dishes.
4.Close the door, then press the start/pause button, the dishwasher
will start running again after 10 seconds.
If the appliance was switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
from the beginning ).
When the working cycle is finished, the buzzer of the dishwasher will sound 8 times, then stop.
Turn off the appliance using the Power button.
Since the appliance is standing by, it will power off automaticly after 30 minutes
without any operation.
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid scald,
as the dishes and utensils are still hot and more susceptible to break.
They also could dry better.
