DOOR REVERSE
The side at which the door opens can be changed,
from the left side (as supplied) to the right side, if the
installation site requires.
Warning!
When reversing the door, the appliance
must not be connected to the mains. Ensure that the
plug is removed from the mains socket.
Note:
Before you start lay the appliance on its back in
order to gain access to the base, you should rest it on
soft foam packaging or similar material to avoid
damaging the backboard. Stand the appliance
upright. Open the door to take out all door racks (to
avoid racks damaged)and then close the door. To
reverse the door, the following steps are generally
recommended.
1. Screw off the four bolts
which in top left with cross
opener and take off the cover.
2. Screw off the one bolt which
in right hinge cover with cross
opener and take it off.
3 . D i s c o n n e c t t h e l i g h t
switch(1) and take it off.
4. Screw off the three bolts in
right hinge and take them off.
5. Disconnect the electrical
connector.
6. Take off the cover on door
right(2) and put the wire into
the hole and cover it
2
-59-