AFTER SALES SUPPORT
1300 777 137
service@unclebills.com.au
MODEL: EA2206 PRODUCT CODE: 708117 04/2022
12
Using the Eye Cup and Sunshade
1. If you wear glasses, fold down the rubber edge
of the eyecup to make it easier to view the entire
image (Fig. 10). After use, return the eyecup to the
fully extended position to ensure the rubber of the
eyecup retains its shape and flexibility.
2. If the sun is at an angle (to the side) instead of
behind you, there may be some glare affecting
the image quality. To reduce the glare, extend the
sunshade simply by pulling it forward (Fig. 11). Once
you are finished using the sunshade, push it back to
its original position.
NOTE: The sun should ideally be located behind you.
If the sun is at an angle, it is recommended to extend
sunshade to reduce any glare.
WARNING: The sun should never be directly in front
of you. Looking directly into the sun is dangerous and
may cause blindness.
INSTRUCTIONS
Using the Pan Lever
1. To unlock the pan lever, turn the knob located
on the left hand side of the tripod anticlockwise
to loosen. You should now be able to pan the
Spotting Scope (moving to the left or right) a full
360° using the pan lever (Fig. 9).
2. Once the Spotting Scope is facing in the desired
direction, turn the knob clockwise to tighten and
secure (lock) the Spotting Scope into position.
NOTE: Do not remove the screw of the pan lever
lock. Only loosen the screw enough so that the pan
lever can be manoeuvred.
NOTE: Never pan the Spotting Scope with the scope itself. Always use the pan lever to
manoeuvre the Spotting Scope.
Fig. 10
Fig. 9
Fig. 11
