AFTER SALES SUPPORT
1300 777 137
service@unclebills.com.au
MODEL: EA2206 PRODUCT CODE: 708117 04/2022
8
GETTING STARTED
Before First Use
Prior to using your Spotting Scope, please read all safety and operating instructions
thoroughly. Please ensure you follow the steps below before using this product.
1. Unpack the product but keep all packaging materials until you have made sure your
new Spotting Scope is undamaged and in good working order.
2. Plastic wrapping can be a suffocation hazard for babies and children so ensure all
packaging materials are kept out of their reach.
3. We recommend you keep the original packaging for storing your Spotting Scope when
not in use.
Setting up the Tripod
The Spotting Scope comes with a tripod which is easy to set up.
Follow the Instructions below for how to set up the tripod.
The tripod has 4 height adjustments; 3 leg height extensions and
the centre pole (vertical) extension.
1. To extend the legs, unclip the leg lock lever and pull the leg
extension out. Press the leg lock lever back into place to secure
the leg into position. Repeat for each leg until the tripod is at
the desired height.
2. To extend the centre pole, turn the vertical extension lock
(screw) anticlockwise until it loosens. Pull the centre pole up
to the desired height, then tighten the vertical extension lock
(screw) clockwise to secure the centre pole into position.
3. Spread the tripod legs (slide the tripod bracket down to the
base of the centre pole) and place the tripod onto a dry, stable
surface (Fig. 1).
NOTE: Always extend the upper leg extension sections first. Only extend the lower leg
extensions when necessary.
NOTE: Once all the legs are fully extended, if you require more height, you can extend
the centre pole. Refer to the instructions above for how to extend the centre pole.
NOTE: Take care when moving! The tripod bracket does not clip into place and will move
up and down the centre pole when the tripod is lifted or moved.
Fig. 1
