© 2000
–2020 signotec GmbH
signotec Delta Pen Display user manual
Page 8 of 15
6.3.
VESA mounting fixture
There are markings for a 75 × 75 mm VESA mounting fixture on the back of the signature pad.
Thermo plastic screws (such as the Ejot or Schriever brand) with a diameter of 3 mm and a
maximum penetration depth of 6.5 mm must be used for mounting.
6.4.
USB cable
The supplied USB Y-cable has three different plugs. The Micro-USB plug is connected to the device.
The black plug provides power and data transfer and the orange plug provides an additional power
supply. Please refer to the
7.
Connection types
The signotec Delta Pen Display signature pad is connected to the computer via USB; there is not an
alternative. If you want to connect a device to a network, then we recommend purchasing a ‘true’
Delta signature pad.
8.
Installation
Make sure that you have installed the
signotec Pen Display Manager
and the
DisplayLink
driver
before you use the device for the first time. You will need to reboot your computer after installing the
drivers. You can then connect the device to your computer.
The device has a removeable USB Y-cable with two standard USB Type A plugs and one Micro-USB
plug. The cable is generally used for data transfer and to power the device. Connect this plug to a free
USB port of the computer. The device can also be operated without a USB connection if it has an
integrated Ethernet connection.
Please install all
required drivers
on your system
before
connecting the device.
Remember to
reboot
your system, as well.
If you use incorrect mounting accessories, it can result in damage to the housing
and the electronics.
Micro-USB connection
USB data connection
USB power connection