© 2000
–2020 signotec GmbH
signotec Gamma user manual
Page 10 of 16
8.
Installation
The device has a removeable USB cable with both a standard USB Type A plug and a Micro-USB plug.
The cable is used for data transfer and to power the device. Connect this plug to a free USB port of
the computer or a signotec USB-to-Ethernet adapter.
The cable is routed through a small channel on the back of the signature pad to provide tension relief.
Attaching the cable without tension relief may damage the cable as well as the device.
Please connect the cable while taking all necessary safety precautions with regard to other devices
and persons. The cable should be routed in such a way that under no circumstances is it constantly
under tension. Do not place heavy objects on the cable, do not bend the cable repeatedly and do not
exert strong pressure on the cable connections. Improper loading of the cable or the connector sockets
may result in cable breakage or damage to the device’s components or your computer. Damage that
can be attributed to these causes is not covered by warranty.
Note:
Please use only the supplied cable or appropriate spare parts from signotec to ensure
correct functionality. The USB standard provides for a maximum cable length of three metres.
signotec cannot guarantee functionality for longer cables.
8.1.
Assembling the pen holder
There is a small cutout on the back of the device to attach the supplied, vertical pen holder. The
rounded, flat end of the pen holder needs to be pressed into this cutout, while applying a little
pressure, in order to ensure that it stays in place.
Please install all
required drivers
on your system
before
connecting the device.
Most drivers are included when installing signotec APIs and other software products
(such as signoSign/2). Otherwise, you can find them at www.signotec.com.
