EN
EN - 8
Inserting a roll
Remove the strip from the roll. Open the top cover and insert the roll into the interior.
Lift the bag holder and pass the end of the roll under the holder.
Making a bag
1. Open the top cover.
2. Make sure that the end of the bag is positioned under the holder and that the bag
cutter is located completely on the edge.
3. Unwind a suf
fi
cient length of the roll. We recommend unwinding at least 8 cm
more than the length of the food.
4. Hold the holder with one hand and cut the roll with the other hand by sliding the
cutter from one side to the other.
5. Place the cut end of the foil on the sealing strip and close up the top cover until
you hear a click on both sides.
6. Plug in the mains plug ad press the
MANUAL SEAL
button to start the sealing
process.
7. Once the seal is made, open the top cover and remove the bag.
Note:
If you do not cut the bag straight, straighten the edge before making the
joint. Use only foils and bags recommended by the manufacturer.
VACUUM&SEAL function
This function is used to extract air from the bag and create a sealing joint.
1. Put the food you want to vacuum seal in the bag. Remove dirt, water, etc. from the
open edge. It is important that the open end of the bag is clean.
2. Insert the open end of the bag into the air extraction chamber and smooth it so
that no folds or ripples form when creating the seal. Make sure that the bag does
not cover the air supply.
3. Close the top cover until you hear a click on both sides.
4. Plug the plug into a power outlet.
5. Select the sealing time by pressing the corresponding button (DRY, MOIST,
EXTENDED).
6. Select the air extraction method (NORMAL, GENTLE).
7. Press
the
VACUUM & SEAL
button, the air extraction process starts automatically
and then the sealing joint is created.
8. The air is extracted out of the bag under high pressure. Carefully monitor the
air extraction process to prevent damage of very fragile foods. When the air is
suf
fi
ciently extracted, press the
MANUAL SEAL
button and the appliance stops the
air extraction automatically and starts creating the seal.
9. The appliance turns off when the seal is made. Take the top cover by the handle, lift
it, and remove the bag.
10. You can always cancel the air extraction process and sealing by pressing the
VACUUM & SEAL
button.
