5.2 ERROR RECOVERY PROCEDURE
When an error occurs, the printer stops printing operation. Moreover, when Busy Output When Error Occurs
is enabled in the Function Settings, the status of data reception becomes busy.
However, Some errors can be recovered to a status just before a printing stop after clearing errors.
Error recovery procedure is shown below.
In this case, the printer resumes the printing from next line or next dot line a print stopped.
Table 5-2 Error Recovery Procedure
Item Recovery
Procedure
Out-of-paper
Cut Paper mode:
Insert the thermal paper from the paper slot, the printer loads
the thermal paper automatically and returns to print-ready
status if the mark is detected. When the mark is not detected,
press the FEED switch to recover to print-ready status .
1
*
Roll Paper / Mark Roll Paper mode:
Open the paper cover and replace the thermal paper. Close
the paper cover, so the printer returns to print-ready status
automatically one second later.
Paper cover open
Close the paper cover, so the printer returns to print-ready
status automatically one second later.
Thermal head temperature error
The printer returns to print-ready status automatically if
thermal head temperature becomes within the stipulated
range.
2
*
Power failure
Return the power supply voltage to the stipulated range, and
then press the FEED switch.
1
*
3
*
Hardware error
Non-recoverable error
*1: In this case, paper feed operation is performed.
*2: Range of stipulated temperature is -5°C
≦
head temperature
≦
75°C
*3: Range of stipulated power supply voltage is 6.5V
≦
power supply voltage
≦
9.7V
5-2
Summary of Contents for DPU-S445 SERIES
