2-7
2
Ba
sic O
pe
ra
tio
n
Roll media installation procedure
1
Open the front cover and slide the media
edge guards to each end of the platen.
Then, close the front cover.
Note
- Move the media edge guards to both ends
so they cannot enter under the media.
- After completing the media replacement work, set the media guards. (
P.2-19
[How to use the media edge guard])
- When using media with adhesive applied to the core at the end of the roll, this
adhesive may stick to the paper guide or the platen. In this case, always clean up
the adhesive before using the media.
If a blower unit is used, move it to a place where it will not disturb the operation.
2
Put the left side media holder in position and
fix it temporarily by turning the screw.
Media replacement
This section describes the
roll media installation / removal procedure
. The
two situations below require roll media replacement:- When the roll media is
finished, the roll media is replaced.
- When the roll media is jammed, the roll media is replaced.
The roll media replacement procedure for each case is shown below.
Summary of Contents for IP-5520
