2-20
How to switch the pressure
Switch over the pressure between the pressure roller and the grit roller used for
media feeding to match different media. The bottom position is normally used.
When skew occurs in the media and the media cannot be fed or when using a
media with weak elasticity such as a thin cloth, switch to [weak], the center posi-
tion. The pressure force is switched using the pressure roller up / down lever. (See
figure below.)
<No pressure> (top)
When loading the media, raise
the lever. This the normal UP
position.
[Rear]
[Front]
<Normal Pressure> (bottom)
When the media is loaded,
lower the lever.
It is the normal DOWN posi-
tion.
<Weak> (in the center)
The pressure becomes weak.
<No pressure> (top)
When loading the media, raise
the lever. This the normal UP
position.
<Normal Pressure> (bottom)
When the media is loaded,
lower the lever.
It is the normal DOWN posi-
tion.
<Weak> (in the center)
The pressure becomes weak.
Summary of Contents for IP-5520
