2-10
9
Slide the flange holder so that the pressure
of pressure roller is equal at edges of the
media.
Note
-
When wrinkles occur on the media, pull the
lifter to release the pressure roller.
(
P.2-27 [How to use the lifter])
- Noting the relationship between the label scale (general rule line) and the media width
will be easier when adjusting the position while loading the media next time.
Note
-
If you shift the media only, skewing will occur. So adjust the load position by
moving the media and flange holder together.
10
Secure the position of flange holders by
tightening the screw of flange holder at the
left hand side.
11
Hold the center of media by hand and turn
back the flange to eliminate the slack.
Note
-
Do not forcibly align the edge surface of
media to the general rule line. Set the media
straight against the roll.
Set so that the end surface of
media comes within this range.
Load the media so that the media is
evenly applied to the pressure roller.
IP-5610取説_E.indb 10
09.4.3 3:13:50 PM