40
40
<Media at the take-up side>
1
Turn off the take-up direction switch.
Take-up direction switch
Outer take-up
- OFF
Inner take-up
2
Open the tension bar guide’s cover.
3
Place the tension bar at the tension bar hook.
Detach the tension bar at the take-up sides.
In case of vinyl chloride media, this procedure is not
necessary at the take-up side, because no tension bar is
used there.
4
Open the front cover, and then cut the media.
Set the cutter to the cutter groove, and cut the media
along the grove.
Platen
Paper guide
Note
-
A net is spread out on the feeding side and take-up side
paper guides, respectively so that the media will not
adhere to the guides.
Do not remove these nets.
-
When cutting the media, be careful not to damage the
paper guide net.
-
Pay attention not to drop the used media so as to avoid
messing up the floor.
Procedure to remove media (scroller) from the printer
5
Set the printer to the offline state by pressing
the
O N L I N E
key.
á
I N K M E D I A R E G
â
ß
M E D I A M . A D V
à
6
Press the
key.
The TUR’s take-up switch is activated by selecting
media and setting the take-up direction switch to ON.
7
Rotate the scroller the wind switch at the
supply side to take up the media.
Take-up reel switch
8
Detach the protection bar.
Protection bar
9
Loosen the right and left knob screws next to
the movable media dryer fan.
Media dryer fan
Knob screw
10
Pull the media dryer fan toward you and turn
it upward 90 degrees.
Media dryer fan
Note
-
When the media dryer fan is turned upward, it slightly goes down
and is fixed. To return the fan to its original position, pull it up and
turn it toward you, and then push it and secure it with the knob
screws.
-
Turn the media dryer fan carefully so that the pressure control
knob and surrounding sheet metals do not get hung up on the
media dryer fan connecting cable.
OFF
