53
52
ENGLISH
#RESEAT PRINTHEAD
>
Used to check the print head.
#WASH PRINTHEADS
>
To prevent the nozzle from clogging, this function is provided to fill the cap with ink so that the print head
(nozzle surface) is soaked in the ink.
PRINTER MENU
Menu
Outline of functions
#CONFIG PRINT
>
Used to print the printer information and operation panel setting information.
#ERROR LOG PRINT
>
Used to print the error log information saved in the printer.
#HISTORY PRINT
>
Used to print the ink system cleaning status and the print head replacement log saved in the printer.
ADJUST MENU
Menu
Outline of functions
#NOZZLE PRINT
#EXECUTE
Print a pattern to check print condition such as missing dots, and set the clogged nozzle numbers based on the
print results.
#PRINT HEAD ADJUST
#EXECUTE
Print a head position adjustment pattern, and enter the head position adjustment value and the L to R
adjustment value based on the print results.
#EDGE SENSOR ADJUST
#EXECUTE
Print a sensor position adjustment pattern and enter the adjustment value for the media horizontal direction
(side direction) based on the print results.
SETUP MENU
Menu
Outline of functions
#LANGUAGE
>JAPANESE
Select the language of messages used for LCD.
#TIME ZONE (GMT+)
>YY/MM/DD HH:MM ZZZ
Select a time zone.
#LENGTH UNITS
>MILLIMETER
Select a length unit.
#TEMPERATURE UNITS
>CENTIGRADE
Select a temperature unit.
#BEEP(UNCAP CARRI)
>ON
Set whether to emit a warning beep in the state below.
- The print head is dislocated from the cap in the daily maintenance or head height adjustment.
- The print head cannot be capped due to a media jam error during printing.
#BEEP(TUR TIMEOUT)
>ON
Set whether to emit a warning beep when a take-up (TUR) timeout has occurred.
#BEEP(INK ERROR)
>ON
Set whether to emit a warning beep when an ink error has occurred.
#BOOT VERSION
*X.XX
Displays the BOOT version.
#PRINTER FW VER
*X.XX_YY
Displays the system firmware version.
#MAIN PCA VER
*XXXXX
Displays the version of the IPB board.
#ACT PCA VER
*X.XX
Displays the version of the ACT board.
#CARRIAGE PCA VER
*XXXXX
Displays the version of the HCB board.
#BTC VER
*XXX
Displays the version of BTC (FPGA).
#USB ADDRESS
*XXX
Displays the USB address.
#USB SPEED
*HIGH-SPEED
Displays the transfer speed of USB connection.
#FACTORY DEFAULT
>
Sets all parameters to the initial settings at factory shipping.
#PRINTER FW UPGRADE
>
Sets the printer to the online update mode.
HEATER MENU
Menu
Outline of functions
#HEATER STANDBY TIME
>30 min
Select the time to maintain the standby set temperature of the heater (including the time for
transition to the standby set temperature) after printing.
