29
(7) Turn the printer over, and make sure that the projection of the partition plate R or partition plate L is fit
properly into the hole of the paper holder (the arrow shown in the figure below).
See "RP-D10 SERIES THERMAL PRINTER TECHNICAL REFERENCE" to set the MS4-4 (Paper Width Selection) to 58mm.
NOTE
◆
Set the paper width before using the printer for the first time. Do not change the paper
width after starting to use the printer. Doing so may damage the printer.
◆
Do not push or pull the tension roller strongly.
◆
When the 58mm width thermal paper is used, rubber crumbs of the platen may be
generated because the platen contacts with the thermal head. Remove rubber
crumbs regularly to maintain printing quality.