8
HARDWARE INSTALLATION
1.
Connect your VGA source, audio source, infrared and RS-232 devices to the transmitting unit
AV-GM03S3-S1[Tx]. If you want to connect to a component video source, please find a
VGA-component breakout cable and link it between the video source and the transmitting unit
of AV-GM03S3-S1.
2.
Connect your VGA display, audio speaker, infrared and RS-232 devices to the receiving unit
AV-GM03S3-S1[Rx]. If you want to connect to a component video display, please find a
VGA-component breakout cable and link it between the video display and the receiving unit of
AV-GM03S3-S1.
3.
Connect a Cat-5/5e/6 cable between the transmitting and receiving units.
4.
Make sure this Cat-5/5e/6 cable is tightly connected and not loose.
5.
Plug in 5V DC power supply unit to the power jack of the receiving unit AV-GM03S3-S1[Rx].
6.
Plug in 5V DC power supply unit to the power jack of the transmitting unit AV-GM03S3-S1[Tx].
7.
If you see the monitor is displaying blurred video or even worse, not displaying at all, please
adjust the EQ and Gain rotary controls to improve the cable skew. GAIN rotary control is to
adjust the gain to an appropriate level for a range of input signal levels (brightness), and EQ
rotary control is to equalize the wave form of the receiving video signal (sharpness). It is
suggested to begin with adjusting the rotary control of EQ to get the input video displayed first,
and then the rotary control of GAIN according to the video you see on the screen.
