15
Necessary parts
• 2 mounting screws
• 2 plugs
How to install
1.
Drill two holes in the wall as indicated on the drawing.
Horizontal distance: 177 mm ± 0.15
2.
At the bottom of Base Unit, turn in 2 flat screws into 2 holes to be fasten enough.
Note: Mounting screws and plugs are not included in the WirelessMedia box . The type of screws depends
on the type of wall (stone, wood, plasterboard, ...) you are mounting the Base Unit to. Make sure the head
of the screw is not larger than the hole in the bottom of base unit.
3.
Place the WMS on the wall and fixate the base unit with the 2 unfixed screws.
Antenna placement rules
The antennas should be oriented vertically, so perpendicular to the ceiling and parallel to the walls.
The antennas should be installed far enough (at least 50cm/1.6ft) from metallic surfaces to avoid
unwanted reflections and far enough (at least 1m/3.3ft) from other radio equipment that operates in
the same frequency range, e.g. other Wi-Fi access points, cordless telephone, microwave ovens,…. It is
also best to install antennas at least 15 cm (6 inches) from concrete walls.
The most favorable situation is a direct line of sight between antennas and Buttons. Any obstruction
will cause the signal to follow a longer propagation path, which can result in performance degradation.
Due to the particular radio pattern of the dipole antennas, the antennas should not be placed just
above potential positions of WirelessMedia users. As a result, the advised position for the antennas is
at the side of the meeting room.
