70
Upgrading firmware of base unit:
There are two ways to upgrade base unit as below
.
First method to upgrade base unit as below:
The base unit device can be updated through a USB drive as below.
1.
Copy the updating file “update.img” to the root directory of the USB drive.
2.
Connect the USB drive to either USB port of
Base-unit
.
Note:
The USB port can only support maximum 500ma. Please use a small power U-disk as
upgrading USB drive.
WirelessMedia recognizes the “
update.img
”-file at a plugged-in USB stick automatically and starts the “Full
Update” procedure.
You can plug out the USB stick within 10 seconds to stop the update.
Attention !
Do not disconnect power during upgrading progress. Or, the unit firmware will be corrupted.
3.
The upgrading progress displays as shown below, and the unit will reboot automatically after complete
the updating 100%, as shown below.
Note:
During the update, screen can be temporary dark.
If the progress bar stops at 1%, use another USB stick, it may be defective.
