71
The display device shows the Home Screen after normal boot of the device, you can disconnect USB-
drive.
4.
Perform “Factory Reset” when the firmware update is complete?
Only when the associated “Release notes” are requiring an additional „
Factory Reset
“, perform it via the
menu “
System settings”
/ “
Reset”
on websever console menu.
All data of configuration will be lost. So that you do not have to re-configure all data in an elaborate
process, therefore note all settings within the Sub-menus before doing Factory Reset.
5.
The update of Base-unit is finished.
Second method to upgrade base unit as below:
Base unit can be upgrade via webserver console menu as below:
Select a “update.img” file to upgrade to target version.
Upgrading and Pairing of Dongle:
1.
Plug the dongle to either of the two USB port of WMS to be updated. It will automatically show up a
message to indicate if the installed firmware of dongle is older, and needs to be upgraded.
Note:
Type C dongle needs to plug into Type-C port of front base unit to upgrade.
The upgrading progress starts automatically with the progress bar, as shown below.
