3
Hardware Installation
1.
Boot up the computer.
2.
Make sure the SATA connector of the
Cool USB 2.0/
eSATA to SATA Docking Duplicator
and SATA hard
disk drive are in alignment. Gently insert the hard
disk drive(s) into the SATA drive slot of the
Cool
USB 2.0/eSATA to SATA Docking Duplicator
.
3.
Plug the included switching power adapter into
the power adapter jack of the
Cool USB 2.0/eSATA
to SATA Docking Duplicator
, then plug the switching
power adapter into a reliable power source.
4.
Use either the included USB 2.0 cable
OR
eSATA
cable to plug the
Cool USB 2.0/eSATA to SATA
Docking Duplicator
into the computer.
Note
: Do not connect both USB 2.0 cable and eSATA
cable at the same time. Plugging in both cables at
the same time may damage the device or computer.
5.
Make sure the operating system has fully started
before proceeding. Power on the
Cool USB 2.0/
eSATA to SATA Docking Duplicator
, make sure that
the 2
Power LEDs
are lit.
Driver Installation
Windows and Mac operating systems will automatically
detect and install the drivers for the
Cool USB 2.0/eSATA
to SATA Docking Duplicator
. No additional driver
installation is needed.
Important
: In order to get high
speed USB 2.0 performance, make sure your USB 2.0
controller has the correct drivers installed.
Summary of Contents for Cool USB 2.0/eSATA to SATA Docking Duplicator
Page 10: ...10 Blank Page ...