SIIG Cool USB 2.0/eSATA to SATA Docking Duplicator, Quick Installation Manual

7

Duplicate Disk

The Duplicate function creates an exact copy of the

source hard disk drive onto the target hard disk drive.

This is a standalone function and works without

computer connection.
1.

Unplug the 

Cool USB 2.0/eSATA to SATA Docking

Duplicator

 from the computer.

2.

Install the source hard disk drive and target hard

disk drive into the appropriate drive bay.  The

target hard disk drive must be of equal or larger

capacity than the source hard disk drive.

3.

Power on the 

Cool USB 2.0/eSATA to SATA Docking

Duplicator.

4.

Press the 

Duplicate

 button, the upper 

Power LED

will flash for several seconds.  When the flashing

stops, press the 

Duplicate

 button again to start the

duplication process.  All 4 LEDs will light up

confirming duplication process is running.  Do not

turn off or unplug the hard drives during the

duplication process.

Note

: Typically, a 1TB hard disk drive will duplicate

in 4 hours (70MB/s average transfer rate) and a

500GB hard disk drive will duplicate in 1.25 hours

(110MB/s average transfer rate).  Your results will

vary according to the speed and capacity of your

hard disk drives.

5.

When the duplication process completes, only the

bottom 

Power LED

 will be on.

6.

Power off the 

Cool USB 2.0/eSATA to SATA Docking

Duplicator

 and remove the target hard disk drive.