4
6.
To install the card, carefully align the card's bus
connector with the selected PCIe slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
7.
Replace the slot bracket holding screw to secure the
card.
8.
Replace the computer cover and reconnect the power
cord.
Driver Installation
This section provides information on how to install the
CyberSerial 4S PCIe
drivers.
Important
: If your system doesn't boot to Windows
properly with our card installed, check with your
system's manufacturer for the latest system firmware
update. Our board comes with a PCI Express
bridge chip, which may not be understood by your
system. At the time this manual was written, many
system and motherboard vendors already have had
this fix posted on their respective web sites.
Windows 2000
1.
At the
Found New Hardware Wizard
, click
Next
.
2.
Select
Search for a suitable driver for my device
(recommended)
, and click
Next
.
3.
Check
Specify a location
, uncheck the other boxes,
then click
Next
.
4.
Insert the driver CD, type in
D:\2000
, then click
OK
.
(Change
D:
to match your CD-ROM drive letter)
5.
Click
Next
and
Finish
.
6.
Repeat steps
1-5
one more time.
7.
Restart Windows to complete the installation.
