3
1.
Turn OFF the power to your computer and any
other connected peripheral devices. Unplug the
computer's power cord.
2.
Remove your computer’s cover and install the card
in an available PCI slot.
3.
Push the board down firmly, but gently, until it is
well seated.
4.
Connect an available 4-pin power connector from
the system power supply to the 4-pin power
connector on the FireWire 800 M-64 (See page 2,
figure 1). This connection is recommended for
reliable power output.
5.
Secure the card and replace the cover.
Software Installation
This section provides information on how to install the
FireWire 800 M-64 drivers.
Windows Driver Installation
Windows 98SE
1.
At the Add New Hardware Wizard, click Next.
2.
Select Search for the best driver for your device
(Recommended), then click Next.
3.
Insert the driver CD, check CD-ROM drive, uncheck
the other boxes, then click Next.
4.
Click Next, then Next again.
5.
If prompted for the Windows 98SE CD, insert it, then
click OK.
6.
Click Finish and restart Windows to complete the
installation.
