13
CONNECT=
Used to establish a connection manually. It is available only
when the adaptor is in the master role.
DEVI-
CE
Connect the adapter to a specified Bluetooth device manually.
It is available only when "DEVICE=xxxxxxxxxxxx" is executed.
1~8
Connect the adapter to a Bluetooth device in the Environment
which found by "SEARCH=?"
xxxxxx-
xxxxxx
Connect the remote adapter by type the MAC address directly
without searching.
?
Display the MAC address of the latest paired device.
Y
Recover the latest connection in the command mode.
N
Disconnect the two adapters in the command mode
P
Connect the previous connected adapter.
DEFAULT=
Used to detect the voltage of the power supply and set the
alert value of low power.
Y
Restore the default settings (e.g. 19200 bps).
The command will re-start the system for 1 second.
DETECT=
Used to detect the voltage of the power supply and set the
alert value of low power.
(Default)
N
Disable the voltage detection
Y
Enable the voltage detection
R
Restore the default value (3.5 Volt)
x.x
Setup the range of voltage detection from 3.0 to 3.7 Volt. The
"x" indicates the number.
?
Inquire the setting status
DEVICE=
For security purpose, this command is used to specify a
unique remote Bluetooth serial adaptor to be connected.
In the master role, the adaptor pairs and connects with the
designated remote slave address. If the adaptor is in the slave
mode, this command is a filter used to accept the inquiry of
the master device.
xxxxxx-
xxxxxx "xxxxxxxxxxxx" is a string of 12 hexadecimal digits.
