14
R
Restore the status so the adaptor can connect with any remote
address.
?
Inquire the designated address that can be paired and
connected.
DIP=
Set the DIP switch function.
?
Inquire the setting status of the DIP switch function.
Y
Turn on the function of the DIP switch. The "ROLE" and
"AUTO" command are not available to set the "Master" or
"Slave".
(Default)
N
Turn off the function of the DIP switch. The "ROLE" and
"AUTO" command are available when the DIP=N.
DISCOVER=
Used to specify whether the adaptor can be discovered or
connected by remote devices.
This command is available only when the adapter is in the
slave role.
N
The adapter is in the undiscoverable mode. If a pair has been
made, the original connection can be resumed. But other
remote master device cannot discover this adapter.
(Default)
Y
The adapter is in the discoverable mode.
?
Inquire the current setting.
ECHO=
Used to specify whether the adapter echoes characters received
from the UART back to the DTE/DCE.
N
Command characters received from the UART are not echoed
back to the DTE/DCE.
(Default)
Y
Command characters received from the UART are echoed back
to the DTE/DCE.
?
Inquire the current setting.
FLOW=
Enables or disables flow control signals (CTS/RTS) of the
UART port. Note: the setting is not affected by DEFAULT.
The command will have 1 second delay.
(Default)
N
Disable flow control.
Y
Enable flow control.
?
Inquire the current setting.
