5
7.
Connect your hard drive(s), then restart the
computer to activate the new firmware.
The firmware update is complete, continue to
Mac OS X
Installation
, on page 5 to complete the installation.
Mac OS X Installation
For a fresh OS X installation:
Use this section when the
Serial ATA 4-Channel PCI-M
will
be the boot controller and Mac OS X will be installed on
a blank or new hard disk drive.
1.
Install the
Serial ATA 4-Channel PCI-M
and attached
drives.
2.
Boot up your computer with the Mac OS X
CD-ROM. Press and hold letter
C
on the keyboard
while your system is booting from the CD-ROM.
3.
When Mac OS X finishes booting, click
Installer
in
the menu bar.
4.
Click
Open Disk Utility
.
5.
Highlight the drive connected to the
Serial ATA 4-Channel PCI-M
and click
Partition
.
Important
: Partitioning the drive will erase all
information on this hard disk drive.
6.
Click
Partition
, click
Partition
again to initialize the
drive.
7.
Close
Disk Utility
when finished and continue
with Mac OS X installation.
For systems that have OS X installed:
Use this section when Mac OS X is already installed and
the
Serial ATA 4-Channel PCI-M
will be used as an add-on
controller.
