4
Figure 3. Connecting the Serial ATA cable
5.
Follow the same instructions when connecting a
second hard drive. Device connection is now
complete.
6.
Close the computer's case then go to Software
Installation to complete the Serial ATA PCI-M
installation.
Software Installation
Mac OSX (v10.2.x) or later drivers are built into the
controller's firmware, no additional driver installation or
firmware update are needed. Go to Mac OS X Installation
on page 5 to complete the installation.
In order for the controller to work in Mac OS X v10.1.x, the
firmware must be updated using the utility on the driver
CD. Go to Mac OS X (v10.1.x) Firmware Update below.
Mac OS X (v10.1.x) Firmware Update
Before installing the update please follow these
guidelines:
•
Make sure no drives are connected to the Serial ATA
PCI-M
•
This utility can only be used in Mac OS X v10.1.x
Serial ATA cable
