6
6.
Click Partition, click Partition again to initialize the
drive.
7.
Close Disk Utility when finished and continue
with Mac OS X installation.
For systems that have OS X installed
Use this section when Mac OS X is already installed and
the controller will be used as an add-on controller.
1.
Install the Serial ATA PCI-M and attached drives.
2.
Boot up your system. When Mac OS finishes
booting, double click Mac OS X drive icon on the
desktop.
Note: If the drive shows up on the desktop properly,
you can choose not to follow steps 3-8.
3.
Double click Applications folder.
4.
Double click Utilities folder.
5.
Double click Disk Utility icon.
6.
Highlight the drive connected to the
Serial ATA PCI-M and click Partition. Important:
Partitioning the drive will erase all information on
this hard disk drive.
7.
Click Partition, click Partition again to initialize the
drive.
8.
Close Disk Utility when finished. The new drive
should appear as Untitled on the desktop.
Troubleshooting
Important: When installing OS X from a boot CD, the
system may not recognize the Serial ATA PCI-M as the
boot controller. If this happens, turn the system off, wait
several seconds, then turn the system back on and
continue with the installation.
