4
Figure 3. Connecting the Serial ATA cable
5.
Follow the same instructions when connecting a
second hard drive. Device connection is now
complete.
6.
Close the computer's case then go to Software
Installation to complete the Serial ATA PCI-M
installation.
Software Installation
The driver for the Serial ATA PCI-M is built into the
controller's firmware, no additional driver installation is
needed. This section provides information on how to
initialize (partition) the hard disk drives.
OS X Installation
Important: Support for Mac OS X v10.1.x will be available
at the end of June, 2004. At that time, check our website
at www.siig.com for more details.
For a fresh OS X installation:
Use this section when the controller will be the boot
controller and Mac OS X will be installed on a blank or
new hard disk drive.
1.
Install the Serial ATA PCI-M and attached drives.
Serial ATA cable