Operating the Calibrator / Micro Calibration Bath
© SIKA • Ba_TP17-TPM-Multi_en.doc • 01/2014
7.3.4.2 Setting the cooling gradient (S version)
The cooling gradient "
SLoF
" is active if the reference temperature is higher than the set tem-
perature.
The setting range extends from 99.99 °C/min up to 0.00 °C/min.
PLEASE NOTE:
The function is deactivated if SLoF = InF (In no Function) has been set.
You are in the
parameter level
.
rEG
appears on the upper display.
SLor
flashes on the lower display.
Use
the
or
key to select the parameter
SLoF
.
rEG
appears on the upper display.
SLoF
flashes on the lower display
Press
the
P
key.
SLoF
flashes on the upper display.
The respective
currently set cooling gradient
appears on the lower display.
Press
the
key to
increase
the cooling gradient
SLoF
.
Press
the
key to
decrease
the cooling gradient
SLoF
.
Press the
and
key to raise and lower the value by 0.1 respectively. If the keys are
held pressed for at least one second, the value increases or decreases quickly and after
two seconds even more quickly; this means the desired value can be reached rapidly.
Press
the
P
key to confirm the set cooling gradient
SLoF
.
The display returns to the parameter level and other parameters can be set.
Automatic return!
If no key is pressed for approx. 15 seconds, the device automatically returns to a previ-
ous level up to the
calibration mode
.
Activate temperature profile!
After carrying out the settings, the calibrator / micro calibration bath uses the new values
only when modifying the set temperature or switching the calibrator / micro calibration
bath off and on again.
Parameters for heating gradient SLor
Cooling gradient entry
Display of the cooling gradient input
