BRAVO MAXIMA II
Operating manual - English
8
Copyright Silca 2011
Fig. 6
3.1
Safety
•
Cutter motor protection
ATTENTION: the cutter motor is protected from overheating by a device (inside the motor) that stops it when
it reaches a dangerous temperature.
This condition can occur when the machine motor is left on continuously, with high ambient
temperatures or in severe working conditions. If the cutter motor overheats it cuts out
automatically. In such cases proceed as follows:
a) turn off the master switch (C).
b) let the motor cool for at least 2 hours then use the machine normally.
•
Start-up
The master switch (C) has a safety function that prevents untimely start-up when voltage returns after
a cut-out.
3.2
Technical Data
ELECTRICAL
PROPERTIES:
230V - 50Hz - 300W - 1,8A
MOTOR:
2 speed single phase asynchronous 230V-50Hz (other voltages on request)
CUTTING TOOL:
Super Rapid Steel (8% Co) / Carbide cutter (only on W-Max version)
MOVEMENTS:
on permanently lubricated bearings and sintered, self-cleaning, self-
lubricating bushings
CLAMP:
high precision, with four sides
SAFETY DEVICES:
motor start-up by means of carriage pick-up with gauges in the idle position
MAXIMUM
LENGTH OF CUTS:
42 mm
ILLUMINATION:
neon lamp
DIMENSIONS:
width: 400 mm depth: 520 mm height: 400 mm
NOISE POTENTIAL:
Lw (A) = 90 dB (A) - speed 1 (steel keys)
Lw (A) = 89,5 dB (A) - speed 2 (brass keys)
WEIGHT:
22,5 Kg.
Summary of Contents for Bravo Maxima II
Page 1: ...Operating manual D432446XA vers 5 0 EN...
Page 4: ......