Operating manual - English
BRAVO MAXIMA II
Copyright Silca 2011
19
U
SING
THE
PINS
For keys with narrow or thin stems one pin must be used (fig. 21-A, fig. 21-B).
For keys with narrow, thin stems, two pins must be used (fig. 21-C), the second one to give a secure
grip on the key.
ATTENTION: the diameter of the pin used for the original key must be the same as that used for the key blank,
so that the two keys are secured in identical positions in the jaws.
ATTENTION: never exchange the clamps.
Fig. 21
6.2
Cutting cruciform keys (with 3 fins)
Ordinary or 4 sided clamps can be used to cut almost all cruciform keys (except Y and T shaped ones)
(fig. 7, page 9).
Positioning cruciform keys:
1) Leave the gauges in the idle position.
2) Fit the original key into the left-hand clamp:
-
insert the grooved bar into the notch on the clamp according to the key stop (as shown in fig.22,
fig.23 and fig.24).
-
butt the key stop up against the bar.
3) Tighten the knob (F) to secure the key.
4) Remove the bar.
5) Repeat the same procedure on the other clamp holding the key blank to be cut (pay attention to the
corresponding fin).
6) Remove the bar.
7) Cut the first fin.
8) Turn the keys in the same direction to cut the other fins.
ATTENTION: the cuts on each fin are different.
POSITION
OF
KEY
AND
BAR
Fig. 22 - Key stop towards the INNER part of the clamp
K
A
B
C
E
Summary of Contents for Bravo Maxima II
Page 1: ...Operating manual D432446XA vers 5 0 EN...
Page 4: ......