Operating manual - English
DELTA 2000 AY
Copyright Silca 1 998
11
6
REGULATION AND USE OF THE MACHINE
6.1
Checking and setting
The cutting tool on the DELTA 2000 AY is used to cut the key blanks and must be periodically checked
and replaced.
Periodically, and whenever the cutting tool is replaced, check the key-cutting machine settings, to ensure
perfect machine efficiency.
Fig. 10
6.2
Gauging
A
XIAL
GAUGING
Axial gauging is regulation of the position of the cutting spaces (fig. 10 - A).
A
XIAL
GAUGING
REGULATION
To regulate the axial gauging, proceed as follows:
WARNING:
disconnect the machine from the mains.
1) set up the coded spacing device (fig. 5, page 4) by means of the knob (E2) so that the indicator "5"
is aligned with position "2" (fig. 11).
2) place the gauging calliper provided in the clamp (A1) (fig. 12), pushing towards the side of the tip stop
(A3), and secure by turning the knob (A).
3) take the carriage towards the cutting tool and place the tracer point (F) all the way into the locating
groove (E3) (fig. 11).
4) check that the cutting tool enters clearly into the groove in the gauging caliper (fig. 12). If adjustment
is necessary, loosen screw (E1) and adjust axial gauging by means of the grub screw (E).
5) when gauging is complete, tighten the screw (E1) well.
Fig. 11
A
B
3
5
2
E2
E
N
O
E1
F
E3
Summary of Contents for Delta 2000 AY
Page 1: ...D413450XA vers 3 0 Operating manual EN...
Page 4: ......
